Hanna-instruments HI 4013 Uživatelský manuál Strana 5

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 4
5
V. V.
V. V.
V.
Equipment required:Equipment required:
Equipment required:Equipment required:
Equipment required:
The HI 4013 requires the Hanna HI 5315 Double
junction reference electrode with HI 7078 as external
electrolyte.
Hanna HI 4222 pH/ISE/mV meter or other suitable
ion or pH/mV meter (Note: log/linear graph paper is
useful if an ISE (ion) meter is not available).
Hanna HI 180 magnetic stirrer or equivalent with
magnetic stirring bars (Note: Isolate beakers from stir-
rer motor heat by placing insulating material such as
foam or cork between them).
Hanna HI 76404 electrode holder or equivalent.
Plastic beakers (HI 740036P) or other suitable mea-
surement vessel.
VI. VI.
VI. VI.
VI.
Solutions RequiredSolutions Required
Solutions RequiredSolutions Required
Solutions Required
Standards for Nitrate Measurements
0.1 M sodium nitrate standard, 500 mL HI 4013-01
100 ppm nitrate standard, 500 mL HI 4013-02
1000 ppm nitrate standard, 500 mL HI 4013-03
Ionic Strength Adjuster
ISA, 500 mL HI 4013-00
ISISA, 500 mL HI 4013-06
Using volumetric pipettes and glassware make dilutions to
bracket the concentration of the samples. Store samples in
plastic bottles. Standards with concentrations < 10
-3
M
should be prepared daily.
Two mL of Hanna ISA HI 4013-00 should be added to 100
mL sample or standard.
HI 4013-06 ISISA is Interferent suppressent ISA. Prepare
by dissolving 17.32g Al
2
(S0
4
)
3
.H
2
0, 3.43.g Ag
2
SO
4
, 1.28g
H
3
BO
4
, 2.52g H
2
NSO
3
H in approximately 800 mL deion-
ized water. Adjust pH to 3 with 0.1 N NaOH. Dilute to 1
liter. Store in a dark colored container.
For drinking water: 10 mL of ISISA should be added to each
50 mL sample or standard.
VIIVII
VIIVII
VII.
General GuidelinesGeneral Guidelines
General GuidelinesGeneral Guidelines
General Guidelines
Ensure the o-ring is installed on modules before screw-
ing into the sensor handle or inner stem.
Zobrazit stránku 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Komentáře k této Příručce

Žádné komentáře