Hanna-instruments HI 83414 Uživatelský manuál stáhnout pdf (Strana 27)

• Close the lid and press the Read key. The display will show the value blinking and the lamp icon

during measurement.

• If Non ratio Turbidity range is selected, the

display will briefly show “Store...” and the two

point calibration is saved. The instrument returns

in the main screen.

• If Ratio Turbidity range is selected, at the end

of the measurement, the third proposed calibration

point (100 NTU) is displayed.

• At this moment it is possible to exit calibration

by pressing the End key.

• If the calibration is terminated, the display will briefly show “Store...” and the two point

calibration is saved. The instrument returns in the main screen.

THREE-POINT CALIBRATION

(Ratio Turbidity only)

To perform a three-point calibration, continue the procedure with the following steps:

• Remove the second standard cuvette.

• Place the 100 NTU standard cuvette (or the

third prepared formazin standard) into the holder,

with the cuvette mark aligned to the sign on the

instrument top.

• Close the lid and press the Read key. The

display will show the value blinking and the lamp

icon during measurement.

• At the end of the measurement, the fourth

proposed calibration point (750 NTU) is displayed.

• At this time it is possible to exit calibration by

pressing the End key.

• If the calibration is terminated, the display will

briefly show “Store...” and the three point

calibration is saved. The instrument returns in the main screen.

FOUR-POINT CALIBRATION

(Ratio Turbidity only)

To perform a four-point calibration, continue the

procedure with the following steps:

• Remove the third standard cuvette.

• Place the 750 NTU standard cuvette (or the

fourth prepared formazin standard) into the holder,

with the cuvette mark aligned to the sign on the

instrument top.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Žádné komentáře

Hanna-instruments HI 83414 Uživatelský manuál Strana 27