Hanna-instruments HI 9813-6N Uživatelský manuál stáhnout pdf

HI 9813-6 pH/EC/TDS/°C meter

with Clean & Cal procedure

Quick Reference Guide

TAKING MEASUREMENTS

• Connect the HI 1285-6 probe and switch the meter ON.

• Submerge the probe into the sample to be tested.

• Select the desired measurement range (pH, mS/cm, ppm, °C)

by pressing the correspondent key.

Note: If the display shows only a “1”, the

meter is out of range.

• Wait for a couple of minutes for reaching

the thermal equilibrium before taking any

measurements.

• After use switch off the instrument, clean and cover the probe

with the protective cap.

Note: It is recommended to clean often the probe with HI 700661

Cleaning Solution.

BATTERY REPLACEMENT

When the battery level is so low that it may cause unreliable

measurements, the meter turns off.

It is recommended to replace the battery immediately.

Unscrew the three screws on the rear of the meter, remove the

battery compartment cover and replace the 9V alkaline battery

with a new one while observing its polarity.

Make sure the battery contacts are tight and secure before

replacing the cover.

www.hannainst.com

1 2

Shrnutí obsahu

Strany 1 - Quick Reference Guide

HI 9813-6 pH/EC/TDS/°C meterwith Clean & Cal procedureQuick Reference GuideTAKING MEASUREMENTS• Connect the HI 1285-6 probe and switch the meter

Strany 2 - CALIBRATION PROCEDURE

CALIBRATION PROCEDURE• Connect the probe and switch the meter ON.• Immerse the probe in the calibration solution.• pH calibration: use HI 7007 (pH 7.0

Komentáře k této Příručce

Žádné komentáře

Hanna-instruments HI 9813-6N Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měřící nástroje Hanna-instruments HI 9813-6N. Hanna Instruments HI 9813-6N User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Hanna-instruments HI 9813-6N